TG-815 TILE & GROUT RENEW

TILE AND GROUT RENEW is a cleaning compound formulated to remove stubborn stains from tile and grout, stone and ceramic tile floors. TILE AND GROUT RENEW’s unique combination of detergents and scouring powders work together to remove dirt, grime, hard water stains and residual sealers and coatings. Caution: TILE AND GROUT RENEW may scratch soft stone, such as marble and limestone. Test in an inconspicuous area prior to use.

Wet the floor thoroughly with clean water and place handfuls of TILE AND GROUT RENEW on the floor, limiting the area to approximately 8 x 10 feet, or at a size managable enough to prevent the cleaning solution from drying during the scrubbing operation. Using a standard speed floor machine equipped with a Nylo-grit scrub brush, spread TILE AND GROUT RENEW evenly over the floor surface and begin scrubbing operation. Slowly scrub the floor back and forth in a "North-South" direction overlapping each pass by 1/2 to 3/4, then scrub in an "East-West "direction. Scrubbing in both directions ensures complete brush contact and thorough cleaning. For edges and hard to reach places, scrub with a grout brush or a “doodle bug” holder equipped with a scrub pad or brush. During scrubbing, be careful not to splash TILE AND GROUT RENEW on vertical surfaces. After scrubbing, immediately pick up the cleaning solution with wet vacuum, flood rinse with clean water and vacuum up rinse solution. Damp mop with tightly rung out mop to remove any residue. Repeat the above steps as necessary.