SS-845 SAFE STRIP

STRIPPER FOR WATER AND SOLVENT BASED SEALERS & PAINTS

$64.19$3,447.95

Clear

SKU: N/A Category:
Contact

Description

SAFE STRIP was developed to provide a more user and environmentally friendly stripper for solventborne and waterborne sealers and paints. SAFE STRIP contains no methylene chloride, is not flammable, and is without the other problems associated with petroleum solvents.

SAFE STRIP is safe to use on concrete, terrazzo (cementitious and resin-based), and masonry surfaces such as brick, natural stone, ceramic tile and quarry tile; it may also be used to strip wood floors down to bare wood. SAFE STRIP is not intended for use on, and will damage, synthetic resilient flooring such as vinyl composition tile, sheet vinyl, luxury vinyl tile and linoleum. If in doubt about using SAFE STRIP on a particular substrate, test in an inconspicuous area or consult SURTEC.

Directions

SAFE STRIP is ready-to-use and is not intended to be diluted with water. Depending on the profile or texture of the surface, apply SAFE STRIP using a mop, appropriate nap roller, or by spraying and then spreading with a deck brush. Work small areas at a time. SAFE STRIP can be very slippery underfoot, so proceed with caution if it is necessary to walk in treated
areas. For solventborne and waterborne sealers and paints allow from at least 15 minutes to 1 hour dwell time, occasionally scrubbing or agitating with a floor buffer with a brush, or by hand with a deck brush. For higher performance two-part urethane coatings, 1 to 3 hours of dwell time may be necessary.

Before picking up the stripper solution, check a small area (~1 square foot) to ensure the seal has been completely removed. If not, allow SAFE STRIP to dwell longer with occasional scrubbing. In most cases, the stripped sealer solution cannot be vacuumed up directly, therefore, when ready for removal, add water or a dilute detergent solution to the surface, scrub into the stripper, and pick up or vacuum the stripper solution using a wet-dry vacuum. Scrub the stripped floor with SURTEC HC-150 diluted 2 oz. per gallon of water, followed by a thorough rinse with water. For wood surfaces, mop the floor several times using a tightly wrung mop with SURTEC NC-125 diluted 4 ounces per gallon. Allow the floor to dry, inspect for residue or unstripped sealer, and repeat the above procedures as necessary.

See Product Data sheet for specific Dwell Times.

Specifications

COLOR: Light straw
ODOR: Sweet, citrus
HMIS RATING: Health = 2 Flammability = 2 Physical Hazard = 0
VOC CONTENT: < 50% by weight
FLASH POINT: 140° F.
DILUTION RATE: Ready to use
METHOD OF APPLICATION: Solvent proof pump-up sprayer, mop, roller, deck brush
COVERAGE: 60 to 100 square feet per gallon
BIODEGRADABLE: Yes
SPECIFIC GRAVITY / DENSITY: 1.0 / 8.3 pounds per gallon
SOLUBILITY IN WATER: Miscible
CONTAINER SIZES AVAILABLE: 4 x 1 gallon jugs
5 gallon pail
55 gallon drum
x
Name(Required)
Hidden
X

Welcome to Surtec! Subscribe to our newsletter for access to exclusive offers and information.

Name(Required)