FP-517 SUPER GLOSS

Excellent gloss that lasts. Responds exceptionally well to maintenance with occasional high speed and ultra high speed buffing. Provides outstanding floor protection and appearance over extended periods of time.

SUPER GLOSS is ideal for building service contractors who need a “dri-brite” finish that can be easily scrubbed and recoated, and will dry to a high shine without burnishing, providing a fast return to service for the floor. SUPER GLOSS exceeds the Coefficient of Friction safety standards of ASTM Designation D-2047.

APPLICATION - Apply thin to medium coats of finish using standard application procedures. As many coats as needed may be applied without intercoat attack, provided each coat is allowed to dry completely. Note: On a bare, stripped floor, four or more coats may be required to achieve the highest level of gloss.

Although not necessary because of SUPER GLOSS’s high initial gloss, occasional high speed buffing SUPER GLOSS will increase shine and appearance, increase safety and durability and prolong the life of the polish. A propane buffer equipped with THERMAL GLOSS pads will achieve excellent buffing results, but any good quality high speed (1000+ rpm) buffer will
achieve suitable results.

MAINTENANCE - Use SURTEC’s LF-150 at 1 or 2 ozs. per gallon of water for damp mopping or scrubbing. Burnish as necessary for gloss recovery.

RECOAT - Scrub the floor with a low speed buffer or automatic scrubber and blue or green (medium scrub) pads using SURTEC LF-150 at a dilution of 2 to 4 ozs. per gallon of water to clean the surface. Rinse the floor with clean water and let dry, then apply one or more coats of SUPER GLOSS, allowing each coat to dry completely before applying the next coat. The last coat may be burnished for gloss enhancement.

STRIPPING - If stripping is necessary, use SURTEC L.O.S., or SUPER STRIP according to label directions.